Blood stains
Blood is a protein stain. Start with cold water on clothes and sheets. Hot water can set it and make it much harder to remove.
These steps are compiled from the sources cited below. BlotLab has not tested these methods ourselves yet. BlotLab test photos coming soon.
Quick answer
For a fresh stain, soak or rinse in cold water — never hot — then launder. The American Cleaning Institute is explicit that hot water can set blood. For a dried stain, pretreat or soak in warm water with an enzyme product, then wash. If a mark remains, rewash with a bleach that is safe for the fabric. Check the stain before it goes in the dryer.
What not to do
- Do not use hot water first. ACI, Iowa State University Extension, and University of Georgia Extension all warn that heat can set a protein stain.
- Do not put clothes or sheets in the dryer, and do not iron them, until the stain is gone.
- Do not use ammonia on silk or wool. UGA Extension says ammonia damages those fibers; if a professional ever uses it, it should be diluted and used sparingly.
- Never mix ammonia with chlorine bleach. That combination releases dangerous gas.
- Do not rub hard. Blot, or gently work detergent in, so you do not spread the stain or rough up the fabric.
Supplies
- Cold water
- Clean white cloths or an absorbent pad
- Liquid laundry detergent or an enzyme pre-soak / enzyme detergent
- Optional, only if the fabric allows it after pretest: 3 percent hydrogen peroxide, or a bleach that is safe for the fabric
- For some upholstery methods described by UGA Extension: a mild detergent, and optionally glycerin, used without ammonia on silk or wool
Cotton or polyester clothing
- Treat immediately. UGA Extension notes that stains set by heat are difficult to remove.
- For a fresh stain: rinse or soak in cold running water. ACI’s fresh-blood method is simply a cold soak, then laundry. UGA Extension also describes rinsing in cold water and gently working in bar soap or liquid detergent, then rinsing and repeating.
- Launder according to the care label. Do not use hot water for this first wash if the stain is still clearly visible; stick with cold or the cooler side of warm once the protein has been flushed.
- For a dried or stubborn stain: ACI says to pretreat or soak in warm water with an enzyme product, then launder. UGA Extension suggests a longer cool-water soak, then a lukewarm enzyme soak, then detergent on any remainder. If a shadow is still there, they describe placing a few drops of 3 percent hydrogen peroxide on the stain for 1 to 3 minutes, rinsing thoroughly, and washing — only after a pretest, and not on colors that are not colorfast.
- If the stain remains, ACI says to rewash using a bleach that is safe for the fabric. Inspect before drying.
Bed sheets
- Strip the bed and treat the sheet as soon as you can. If blood has reached a mattress pad, treat that separately with the same cold-water approach, and blot a mattress surface with cold water rather than soaking it.
- Rinse or soak the stained area in cold water in a tub or sink. Gently work in liquid or enzyme detergent. Fresh stains on cotton or polyester sheets often lift with this step alone, which matches ACI’s fresh-blood method.
- Wash the whole sheet in cold or warm water with enzyme detergent, following the care label. White cotton sheets may tolerate a bleach that is safe for the fabric if a mark remains after the first wash; colored sheets should get oxygen bleach, not chlorine, unless the label clearly allows it.
- For dried blood on sheets, soak in an enzyme product (ACI allows warm water for this enzyme soak), then wash and inspect. Repeat before the dryer. A second cold soak is better than heat.
Delicates (silk or wool)
- If the item is dry-clean only, blot with cold water only and take it to a professional. Tell them it is blood.
- For washable silk or wool, UGA Extension says to start by sponging or blotting with cold water. If stain remains, they describe a “wet spotter” of 1 part glycerin, 1 part white dishwashing detergent, and 8 parts cold water, used under an absorbent pad that is kept moist and changed as it picks up color, then flushed and blotted with cool water. Pretest first. Do not add ammonia on silk or wool.
- Air-dry away from heat. Do not use chlorine bleach or hot water.
Carpet or upholstery
- Blot — do not rub — with a clean white cloth and cold water. UGA Extension repeats that you should always use cool water on blood and treat it as soon as possible.
- On synthetic carpet, mix 1 teaspoon of a mild, non-alkaline detergent with 1/2 pint (1 cup) of cool water. Apply a little and blot until no more color transfers. Do not force liquid deep into the pile or the backing.
- If a mark remains on synthetic fiber, UGA Extension describes sponging with 1 tablespoon ammonia in 1/2 cup water, then blotting, and drying under a weighted absorbent pad. Skip this ammonia step on wool. On wool, stay with the mild detergent and cool water.
- On upholstery, blot with cold water first. Avoid over-wetting, which can leave a ring. Silk or wool upholstery should not get ammonia. If the stain has set or the fabric is delicate or unknown, stop and call a professional cleaner.
Sources
We compiled these steps from the following published guides. We have not independently verified every product or method in a BlotLab test.
- American Cleaning Institute, Stain Removal Guide (fresh and dried blood) — updated March 31, 2026
- University of Georgia Extension, Remove Stains From Blood
- Iowa State University Extension and Outreach, Holiday Stains (protein stains and cold water) — December 13, 2022
- K-State Research and Extension, Stain Removal (fresh and dried blood)
Always read the care label, pretest a cleaner on a hidden area, and keep stain-removal products away from children and pets. Never mix chlorine bleach with ammonia or other cleaners. Do not put an item in the dryer until the stain is gone — heat can set it.